Hardware

Thermal Grizzly clarifies WireView Pro II extended GPU warranty conditions

By One Percent Lows
★ Add us as a preferred source on Google

TL;DR

Thermal Grizzly says its WireView Pro II warranty covers 12VHPWR or 12V-2x6 connector damage and resulting GPU damage for 24 months.

Thermal Grizzly published an FAQ detailing the conditions for its WireView Pro II extended GPU warranty. The 24-month warranty covers damage to the 12VHPWR or 12V-2x6 connector and any resulting damage to the GPU. This coverage applies only to the original buyer with proof of purchase and remains valid even after a GPU's own warranty ends. Thermal Grizzly says the warranty does not cover power supply units or unrelated faults.

Users must keep monitoring enabled to maintain coverage. While users can lower current, temperature, or power thresholds, Thermal Grizzly says raising them above default settings is not allowed. Shunt mods, commercial mining, and using an XOC BIOS with a raised power target are excluded from coverage.

Third-party extensions between the WireView Pro II and the GPU are permitted if each 12V line stays separate. Thermal Grizzly says adapters that bridge these lines internally are not covered because they prevent the device from reading current on each GPU power contact. Regarding setup, Thermal Grizzly says the USB cable and motherboard Y-splitter do not need to be connected for the warranty to apply, though they recommend the Y-splitter for shutting down the PC through the power-button header. If a repair attempt fails, Thermal Grizzly says it will send a card with comparable performance, though it may not be the same brand or edition.

More on Thermal Grizzly